OS10 Enterprise Edition User Guide Release 10.4.1.0

PDF

enable

Enables tracking of an uplink-state group.

Syntax
enable
Parameters
None
Default
Disabled
Command Mode
UPLINK-STATE-GROUP
Usage Information
The no version of this command disables tracking of an uplink-state group.
Example
OS10(config)# uplink-state-group 1
                                       OS10(conf-uplink-state-group-1)# enable
                                    
Supported Releases
10.4.0E(R3) or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\