OS10 Enterprise Edition User Guide Release 10.4.1.0

PDF

Ethernet interfaces

Ethernet port interfaces are enabled by default. To disable an Ethernet interface, enter the shutdown command.

To re-enable a disabled interface, enter the no shutdown command.

  1. Configure an Ethernet port interface from global CONFIGURATION mode.
    interface ethernet 
                                           node/slot/port[:subport]
                                        
  2. Disable and re-enable the Ethernet port interface in INTERFACE mode.
    shutdown
    no shutdown
Disable Ethernet port interface
OS10(config)# interface ethernet 1/1/1
                                    OS10(conf-if-eth1/1/1)# shutdown
                                 
Enable Ethernet port interface
OS10(config)# interface ethernet 1/1/1
                                    OS10(conf-if-eth1/1/1)# no shutdown
                                 

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\