OS10 Enterprise Edition User Guide Release 10.4.1.0

PDF

fip-snooping enable

Enables FIP snooping on specified VLAN.

Syntax
fip-snooping enable
Parameters
None
Defaults
Disabled
Command Mode
VLAN INTERFACE
Usage Information

The no version of this command disables FIP snooping on the VLAN.

You can enable FIP snooping on a VLAN only after enabling the FIP snooping feature globally using the feature fip-snooping command. OS10 supports FIP snooping on a maximum of 12 VLANs.

Example
OS10(config)# interface vlan 3
                                       OS10(conf-if-vl-3)# fip-snooping enable
                                    
Supported Releases
10.4.0E(R1) or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\