OS10 Enterprise Edition User Guide Release 10.4.1.0

PDF

hash-algorithm

Changes the hash algorithm that distributes traffic flows across ECMP paths and the LAG.

Syntax
hash-algorithm {ecmp | lag} crc
Parameters
  • ecmp — Enables ECMP hash configuration.
  • lag — Enables LAG hash configuration for L2 only.
  • crc — Enables CRC polynomial for hash computation.
Default
crc
Command Mode
CONFIGURATION
Usage Information

The hash value calculated with this command is unique to the entire system. Different hash algorithms are based on the number of port-channel members and packet values. The default hash algorithm yields the most balanced results in various test scenarios, but if the default algorithm does not provide a satisfactory distribution of traffic, use this command to designate another algorithm.

When a port-channel member leaves or is added to the port-channel, the hash algorithm is recalculated to balance traffic across the members. The no version of this command returns the value to the default.

Example
OS10(config)# hash-algorithm lag crc
Supported Releases
10.3.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\