OS10 Enterprise Edition User Guide Release 10.4.1.0

PDF

in-band-mgmt

Configures the front-panel ports as the management interface that the SDN controller connects to.

Syntax
in-band-mgmt interface ethernet node/slot/port[:subport]
Parameters
node/slot/port[:subport] —Enter the physical port information.
Default
None
Command Mode
OPENFLOW CONFIGURATION
Usage Information

Use this command to convert any one of the front-panel ports as the management interface. This port is not part of the OpenFlow logical switch instance. All the ports are L2 ports by default. If you configure one of the front-panel ports as the management interface, the port becomes an L3 port. You can configure an L3 IPv4 address only to the front-panel port that you have specified in this command. Ensure that you have IP connectivity between the specified port and the controller.

The no form of this command removes this configuration and the front-panel port becomes part of the OpenFlow logical switch instance.

Example
                                       OS10# configure terminal
                                       OS10(config)# openflow
                                       OS10 (config-openflow)# in-band-mgmt interface ethernet 1/1/1
                                       OS10 (config-openflow)# no shutdown
                                       
                                    
Supported Releases
10.4.1 or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\