OS10 Enterprise Edition User Guide Release 10.4.1.0

PDF

ip igmp query-max-resp-time

Configures the maximum time for responding to a query advertised in IGMP queries.

Syntax
ip igmp snooping query-max-resp-time query-response-time
Parameters
query-response-time —Enter the query response time in seconds, ranging from 1 to 25.
Default
10 seconds
Command Mode
VLAN INTERFACE
Usage Information
The no version of this command resets the query response time to default value.
Example
OS10(config)# interface vlan 100
                                       OS10(conf-if-vl-100)# ip igmp snooping query-max-resp-time 15
                                       
                                    
Supported Releases
10.4.1.0 or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\