OS10 Enterprise Edition User Guide Release 10.4.1.0

PDF

ip igmp snooping fast-leave

Enables fast leave in IGMP snooping for specified VLAN.

Syntax
ip igmp snooping fast-leave
Parameters
None
Default
Disabled
Command Mode
VLAN INTERFACE
Usage Information
The fast leave option allows the IGMP snooping switch to remove an interface from the multicast group immediately on receiving the leave message. The no version of this command disables the fast leave functionality.
Example
OS10(config)# interface vlan 100
                                       OS10(conf-if-vl-100)# ip igmp snooping fast-leave
                                       
                                    
Supported Releases
10.4.1.0 or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\