OS10 Enterprise Edition User Guide Release 10.4.1.0

PDF

ip ospf area

Attaches an interface to an OSPF area.

Syntax
ip ospf process-id area area-id
Parameters
  • process-id — Set an OSPF process ID for a specific OSPF process (1 to 65535)
  • area area-id — Enter the OSPF area ID in dotted decimal format (A.B.C.D.) or enter an area ID number (1 to 65535).
Default
Not configured
Command Mode
INTERFACE
Usage Information
The no version of this command removes an interface from an OSPF area.
Example
OS10(conf-if-vl-10)# ip ospf 10 area 5
                                       
                                    
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\