OS10 Enterprise Edition User Guide Release 10.4.1.0

PDF

ip ospf mtu-ignore

Enables OSPF MTU mismatch detection on receipt of DBD packets.

Syntax
ip ospf mtu-ignore
Parameters
None
Default
Not configured
Command Mode
INTERFACE
Usage Information
When neighbors exchange DBD packets, the OSPF process checks if the neighbors are using the same MTU on a common interface. If the receiving MTU in the DBD packet is higher than the IP MTU configured on the incoming interface, OSPF adjacency does not establish. The no version of this command disables the IP OSPF mtu-ignore configuration.
Example
OS10(conf-if-vl-10)# ip ospf mtu-ignore
                                       
                                    
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\