OS10 Enterprise Edition User Guide Release 10.4.1.0

PDF

ip telnet server enable

Enables Telnet TCP/IP connections to an OS10 switch.

Syntax
ip telnet server enable
Parameters
None
Default
Disabled
Command Mode
CONFIGURATION
Usage Information
By default, the Telnet server is disabled. When you enable the Telnet server, use the IP address configured on the management or any front-panel port to connect to an OS10 switch. After you reload the switch, the Telnet server configuration is maintained. To verify the Telnet server configuration, enter the show running-configuration command.
Example
OS10(config)# ip telnet server enable
Example (disable)
OS10(config)# no ip telnet server enable
Supported Releases
10.4.0E(R1) or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\