OS10 Enterprise Edition User Guide Release 10.4.1.0

PDF

ip vrf

Create a non-default VRF instance.

Syntax
ip vrf vrf-name
Parameters
  • vrf-name —Enter the name of the non-default VRF that you want to create. Enter a VRF name that is not greater than 32 characters in length.
Default
Not configured
Command Mode
CONFIGURATION
Usage Information
Enter the ip vrf vrf-name command only in non-transaction-based configuration mode. Do not use transaction-based mode. You can create up to a maximum of 16 non-default VRF instances. The no ip vrf vrf-name command removes the non-default VRF instance that you specify.
Example
OS10(config)# ip vrf vrf-test
                                       OS10(conf-vrf-test)#
                                    
Supported Releases
10.4.1.0 or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\