OS10 Enterprise Edition User Guide Release 10.4.1.0

PDF

ipv6 access-group

Configures an IPv6 access group.

Syntax
ipv6 access-group access-list-name {in | out}
Parameters
  • access-list-name — Enter the name of an IPv6 ACL. A maximum of 140 characters.
  • in — Apply the ACL to incoming traffic.
  • out — Apply the ACL to outgoing traffic.
Default
Not configured
Command Mode

INTERFACE

CONTROL-PLANE

Usage Information
Use this command in the CONTROL-PLANE mode to apply a control-plane ACL. Control-plane ACLs are only applied on the ingress traffic. By default, the control-plane ACL is applied to the front-panel ports as well as the management port. The no version of this command deletes an IPv6 ACL configuration.
Example
OS10(conf-if-eth1/1/8)# ipv6 access-group test6 in
Example (Control-plane ACL)
OS10# configure terminal
                                       OS10(config)# control-plane
                                       OS10(config-control-plane)# ipv6 access-group aaa-cp-acl in
                                    
Supported Releases
10.2.0E or later ; 10.4.1 or later (control-plane ACL)

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\