OS10 Enterprise Edition User Guide Release 10.4.1.0

PDF

ipv6 mld snooping query-interval

Configures the time interval for sending MLD general queries.

Syntax
ipv6 mld snooping query-interval query-interval-time
Parameters
query-interval-time —Enter the interval time in seconds, ranging from 2 to 18000.
Default
60 seconds
Command Mode
VLAN INTERFACE
Usage Information
The no version of this command resets the query interval to the default value.
Example
OS10(config)# interface vlan 100
                                       OS10(conf-if-vl-100)# ipv6 mld snooping query-interval 120
                                       
                                    
Supported Releases
10.4.1.0 or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\