OS10 Enterprise Edition User Guide Release 10.4.1.0

PDF

ipv6 ospf area

Attaches an interface to an OSPF area.

Syntax
ipv6 ospf process-id area area-id
Parameters
  • process-id —Enter an OSPFv3 process ID for a specific OSPFv3 process (1 to 65535).
  • area-id—Enter the OSPFv3 area ID in dotted decimal format (A.B.C.D) or enter an area ID number (1 to 65535).
Default
Not configured
Command Mode
INTERFACE
Usage Information
The no version of this command removes an interface from an OSPFv3 area.
Example
                                       OS10(config)# interface vlan 10
                                       OS10(conf-if-vl-10)# ipv6 ospf 10 area 1
                                       
                                    
Supported Releases
10.3.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\