OS10 Enterprise Edition User Guide Release 10.4.1.0

PDF

ipv6 ospf hello-interval

Sets the time interval between hello packets sent on an interface.

Syntax
ipv6 ospf hello-interval seconds
Parameters
seconds — Enter the hello-interval value in seconds (1 to 65535).
Default
10 seconds
Command Mode
INTERFACE
Usage Information
All routers in a network must have the same hello time interval between the hello packets. The no version of the this command resets the value to the default.
Example
OS10(config)# interface vlan 10
                                       OS10(conf-if-vl-10)# ipv6 ospf hello-interval 30
                                    
Supported Releases
10.3.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\