OS10 Enterprise Edition User Guide Release 10.4.1.0

PDF

ipv6 prefix-list permit

Creates a prefix-list to permit route filtering from a specified IPv6 network address.

Syntax
ipv6 prefix-list prefix-list-name permit {A::B/x [ge | le] prefix-len}
Parameters
  • prefix-list-name — Enter the IPv6 prefix-list name.
  • A::B/x — Enter the IPv6 address to permit.
  • ge — Enter to indicate the network address is greater than or equal to the range specified.
  • le — Enter to indicate the network address is less than or equal to the range specified.
  • prefix-len — Enter the prefix length.
Defaults
Not configured
Command Mode
CONFIGURATION
Usage Information
The no version of this command removes the specified prefix-list.
Example
OS10(config)# ipv6 prefix-list TEST permit AB20::1/128 ge 10 le 30
Supported Release
10.3.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\