OS10 Enterprise Edition User Guide Release 10.4.1.0

PDF

ipv6 unreachables

Enables the generation of error messages on an interface for IPv6 packets with unreachable destinations.

Syntax
ipv6 unreachables
Parameters
None
Defaults
ICMPv6 unreachable messages are not sent.
Command Mode
INTERFACE
Usage Information
  • By default, when no matching entry for an IPv6 route is found in the IPv6 routing table, the packet is dropped and no error message is sent. Use this command to enable sending an IPv6 destination unreachable error message to the source without dropping the packet.
  • The no version of this command disables the generation of unreachable destination messages.
Example
OS10(config)# interface ethernet 1/2/3
                                       OS10(conf-if-eth1/2/3)# ipv6 unreachables
                                    
Supported Releases
10.4.0E(R1) or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\