OS10 Enterprise Edition User Guide Release 10.4.1.0

PDF

iscsi session-monitoring enable

Enables iSCSI session monitoring.

Syntax
iscsi session-monitoring enable
Parameter
None
Default
Disabled
Command Mode
CONFIGURATION
Usage Information
Use the iscsi aging time command to configure the aging timeout in iSCSI monitoring sessions, and use the iscsi target port command to configure the TCP ports that listen for connected storage devices in iSCSI monitoring sessions. The no version of this command disables iSCSI session monitoring.
  • NOTE: When iSCSI session monitoring is enabled, you can monitor a maximum of 100 connections.
Example
OS10(config)# iscsi session-monitoring enable 
Supported Releases
10.3.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\