OS10 Enterprise Edition User Guide Release 10.4.1.0

PDF

lldp enable

Enables or disables LLDP globally.

Syntax
lldp enable
Parameters
None
Default
Enabled
Command Mode
CONFIGURATION
Usage Information
This command enables LLDP globally for all Ethernet (PHY) interfaces, except on those interfaces where LLDP is manually disabled. The no version of this command disables LLDP globally irrespective of whether LLDP is manually enabled on an interface.
Example
OS10(config)# lldp enable
Supported Releases
10.3.1E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\