OS10 Enterprise Edition User Guide Release 10.4.1.0

PDF

lldp med

Enables or disables LLDP-MED on an interface.

Syntax
lldp med {enable | disable}
Parameters
  • enable — Enable LLDP-MED on the interface.
  • disable — Disable LLDP-MED on the interface.
Default
Enabled with network-policy TLV
Command Mode
INTERFACE
Usage Information
LLDP-MED communicates the types of TLVs that the endpoint device and the network connectivity device support. Use the no lldp med or lldp med disable command to disable LLDP-MED on a specific interface.
Example
OS10(conf-if-eth1/1/1)# lldp med disable
                                       
                                    
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\