OS10 Enterprise Edition User Guide Release 10.4.1.0

PDF

lldp reinit

Configures the delay time (in seconds) for LLDP to initialize on any interface.

Syntax
lldp reinit seconds
Parameters
seconds — Enter the delay timer value in seconds (1 to 10).
Default
2 seconds
Command Mode
CONFIGURATION
Usage Information
The no version of this command resets the value to the default.
Example
OS10(config)# lldp reinit 5
                                       
                                    
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\