OS10 Enterprise Edition User Guide Release 10.4.1.0

PDF

lldp tlv-select dot3tlv

Enables or disables the dot3 TLVs to transmit in LLDP packets.

Syntax
lldp tlv-select dot3tlv {macphy-config | max-framesize}
Parameters
  • macphy-config — Enable the port VLAN ID TLV.
  • max-framesize — Enable maximum frame size TLV.
Default
Enabled
Command Mode
INTERFACE
Usage Information
The no version of this command disables TLV transmission.
Example
OS10(conf-if-eth1/1/3)# lldp tlv-select dot3tlv macphy-config
                                       
                                    
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\