OS10 Enterprise Edition User Guide Release 10.4.1.0

PDF

location-led interface

Changes the location LED of the interface.

Syntax
location-led interface ethernet { chassis/slot/port[:subport]} {on | off}
Parameters
  • chassis/slot/port[:subport] — Enter the ethernet interface number.
  • on | off — Set the interface LED to be on or off.
Default
Not configured
Command Mode
EXEC
Usage Information
Use the location-led interface command to change the location LED for the specified interface.
Example
OS10# location-led interface ethernet 1/1/1 on
                                       OS10# location-led interface ethernet 1/1/1 off
                                    
Supported Releases
10.3.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\