OS10 Enterprise Edition User Guide Release 10.4.1.0

PDF

location-led system

Changes the location LED of the system.

Syntax
location-led system { node-id | node-id/unit-id} {on | off}
Parameters
  • node-id | node-id/unit-id — Enter the system ID.
  • on | off — Set the system LED to be on or off.
Default
Not configured
Command Mode
EXEC
Usage Information
Use the location-led system command to change the location LED for the specified system ID.
Example
OS10# location-led system 1 on
                                       OS10# location-led system 1 off
                                    
Supported Releases
10.3.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\