OS10 Enterprise Edition User Guide Release 10.4.1.0

PDF

match dscp

Configures a DSCP value as a match criteria for a class-map.

Syntax
match [not] {ip | ipv6 | ip-any } dscp [ dscp-list | dscp-list]
Parameters
  • not — (Optional) Enter to cancel a previously applied match criteria.
  • ip — Enter to use IPv4 protocol as the match protocol.
  • ipv6 — Enter to use IPv6 protocol as the match protocol.
  • ip-any — Enter to use both IPv4 and IPv6 as the match protocol.
  • dscp dscp-list | dscp-list — Enter a DSCP value in single numbers, comma separated, or a hyphenated range (0 to 63).
Default
Not configured
Command Mode
CLASS-MAP
Usage Information
You cannot enter two match statements with the same filter-type. If you enter two match statements with the same filter-type, the second statement overwrites the first statement. The match-all option in a class-map does not support ip-any. Select either ip or IPv6 for the match-all criteria. If you select ip-any, you cannot select ip or ipv6 for the same filter type.
Example
OS10(conf-cmap-qos)# match ip-any dscp 17-20
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\