OS10 Enterprise Edition User Guide Release 10.4.1.0

PDF

Match routes

Configure match criterion for a route-map. There is no limit to the number of match commands per route map, but keep the number of match filters in a route-map low. The set commands do not require a corresponding match command.

  • Match routes with a specific metric value in ROUTE-MAP mode, 0 to 4294967295.
    match metric 
                                           metric-value
                                        
  • Match routes with a specific tag in ROUTE-MAP mode, 0 to 4294967295.
    match tag 
                                           tag-value
                                        
  • Match routes whose next hop is a specific interface in ROUTE-MAP mode.
    match interface 
                                           interface
                                        
    • ethernet — Enter the Ethernet interface information.
    • port-channel — Enter the port-channel number.
    • vlan — Enter the VLAN ID number.

Check match routes

OS10(config)# route-map test permit 1
                                 0S10(conf-route-map)# match tag 250000
                                 OS10(conf-route-map)# set weight 100
                              

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\