OS10 Enterprise Edition User Guide Release 10.4.1.0

PDF

member (zoneset)

Adds zones to an existing zoneset.

Syntax
member zone-name
Parameters
zone-name — Enter an existing zone name.
Defaults
Not configured
Command Mode
Zoneset CONFIGURATION
Usage Information

The no version of this command removes the zone from the zoneset.

Example
OS10(config)# fc zoneset set
                                       OS10(conf-fc-zoneset-set)# member hba1
                                       
                                    
Supported Releases
10.3.1E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\