OS10 Enterprise Edition User Guide Release 10.4.1.0

PDF

non-deterministic-med

Compares paths in the order they arrive.

Syntax
non-deterministic-med
Parameters
None
Default
Disabled
Command Mode
ROUTER-BGP
Usage Information
Paths compare in the order they arrive. OS10 uses this method to choose different best paths from a set of paths, depending on the order they are received from the neighbors. MED may or may not be compared between adjacent paths. When you change the path selection from deterministic to non-deterministic, the path selection for the existing paths remains deterministic until you use the clear ip bgp command to clear the existing paths. The no version of this command configures BGP bestpath selection as non-deterministic.
  • NOTE: To configure these settings for a non default VRF instance, you must first enter the ROUTER-CONFIG-VRF sub mode using the following commands:
    1. Enter the ROUTER BGP mode using the router bgp as-number command.
    2. From the ROUTER BGP mode, enter the ROUTER BGP VRF mode using the vrf vrf-name command.
Example
OS10(conf-router-bgp-10)# non-deterministic-med
                                       
                                    
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\