OS10 Enterprise Edition User Guide Release 10.4.1.0

PDF

ntp authenticate

Enables authentication of NTP traffic between the device and the NTP time serving hosts.

Syntax
ntp authenticate
Parameters
None
Default
Not configured
Command Mode
CONFIGURATION
Usage Information
You must also configure an authentication key for NTP traffic using the ntp authentication-key command. The no version of this command disables NTP authentication.
Example
OS10(config)# ntp authenticate
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\