OS10 Enterprise Edition User Guide Release 10.4.1.0

PDF

ntp broadcast client

Configures the interface to receive NTP broadcasts from an NTP server.

Syntax
ntp broadcast client
Parameters
None
Default
Not configured
Command Mode
INTERFACE
Usage Information
The no version of this command disables broadcast.
Example
OS10(conf-if-eth1/1/1)# ntp broadcast client
                                       
                                    
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\