OS10 Enterprise Edition User Guide Release 10.4.1.0

PDF

ntp source

Configures an interface IP address to include in NTP packets.

Syntax
ntp source interface
Parameters
interface — Set the interface type:
  • ethernet node/slot/port[:subport] — Enter the Ethernet interface information.
  • port-channel id-number — Enter the port-channel number (1 to 128).
  • vlan vlan-id — Enter the VLAN number (1 to 4093).
  • loopback loopback-id — Enter the Loopback interface number (0 to 16383).
  • mgmt node/slot/port — Enter the Management port interface information.
Default
Not configured
Command Mode
CONFIGURATION
Usage Information
The no version of this command removes the configuration.
Example
OS10(config)# ntp source ethernet 1/1/24
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\