OS10 Enterprise Edition User Guide Release 10.4.1.0

PDF

OpenFlow-only mode commands

When you configure the switch to OpenFlow-only mode, only the following commands are available; all other commands are disabled.

  • NOTE:
    • The ntp subcommand under the interface command is not applicable when the switch is in OpenFlow mode.
    • The ip and ipv6 subcommands under the interface command are applicable only when you configure the interface as the management port using the in-band-mgmt command.
    • The ip and ipv6 commands must be used only in In-Band mode (using the in-band-mgmt command).
Table 1. Modes and CLI commands. Modes and CLI commands
Mode Available CLI commands
CONFIGURATION aaa
alias
banner
class-map
clock
control-plane
crypto
end
eula-consent
exec-timeout
exit
feature
help
host-description
hostname
interface
ip
  • ip access-list
  • ip route
  • ip ssh
  • ip telnet
ipv6
  • ip access-list
line
logging
login
management
no
ntp
openflow
password-attributes
policy-map
radius-server
rest
scale-profile
support-assist
system
tacacs-server
trust
username
userrole
EXEC All commands

The following debug commands are not available:

  • debug iscsi
  • debug radius
  • debug tacacs+
LAG INTERFACE CONFIGURATION

LAG is not supported.

LOOPBACK INTERFACE CONFIGURATION

Loopback interface is not supported.

INTERFACE CONFIGURATION description
end
exit
ip
mtu
negotiation
ntp
show
shutdown
VLAN INTERFACE CONFIGURATION

VLAN is not supported.


Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\