OS10 Enterprise Edition User Guide Release 10.4.1.0

PDF

permit ip

Configures a filter to permit all or specific packets from an IP address.

Syntax
permit ip [A.B.C.D | A.B.C.D/x | any | host ip-address] [[A.B.C.D | A.B.C.D/x | any | host ip-address] [capture | dscp | fragments]
Parameters
  • A.B.C.D — Enter the IP address in dotted decimal format.
  • A.B.C.D/x — Enter the number of bits to match to the dotted decimal address.
  • any — (Optional) Set all routes which are subject to the filter:
    • capture — (Optional) Capture packets the filter processes.
    • dscp value — (Optional) Permit a packet based on the DSCP values, from 0 to 63.
    • fragments — (Optional) Use ACLs to control packet fragments.
  • host ip-address — (Optional) Enter the IP address to use a host address only.
Default
Not configured
Command Mode
IPV4-ACL
Usage Information
The no version of this command removes the filter.
Example
OS10(conf-ipv4-acl)# permit ip any any capture session 1
                                       
                                    
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\