OS10 Enterprise Edition User Guide Release


permit (IPv6)

Configures a filter to allow packets with a specific IPv6 address.

permit [ protocol-number | icmp | ipv6 | tcp | udp] [A::B | A::B/x | any | host ipv6-address] [A::B | A:B/x | any | host ipv6-address] [capture | dscp value | fragment]
  • protocol-number — (Optional) Enter the protocol number identified in the IPv6 header, from 0 to 255.
  • icmp — (Optional) Enter the ICMP address to permit.
  • ipv6 — (Optional) Enter the IPv6 address to permit.
  • tcp — (Optional) Enter the TCP address to permit.
  • udp — (Optional) Enter the UDP address to permit.
  • A::B — Enter the IPv6 address in hexadecimal format separated by colons.
  • A::B/x — Enter the number of bits that must match the IPv6 address.
  • any — (Optional) Set all routes which are subject to the filter:
    • capture — (Optional) Capture packets the filter processes.
    • dscp value — (Optional) Permit a packet based on the DSCP values, from 0 to 63.
    • fragment — (Optional) Use ACLs to control packet fragments.
  • host ip-address — (Optional) Enter the IPv6 address to use a host address only.
Not configured
Command Mode
Usage Information
The no version of this command removes the filter.
OS10(config)# ipv6 access-list ipv6test
                                       OS10(conf-ipv6-acl)# permit udp any any capture session 1
Supported Releases
10.2.0E or later

Rate this content

Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\