OS10 Enterprise Edition User Guide Release



Configures priority flow-control for cost of service (CoS).

pfc-cos cos-value
cos-value — Enter a single, comma-delimited, or hyphenated range of CoS values for priority flow-control to enable (0 to 7).
Not configured
Command Mode
Usage Information
To configure link-level flow-control, do not configure pfc-cos for the matched class for this policy. Add the policy-map with the pfc-cos configuration to system-qos to service an input to enable priority flow-control behavior on all ports, based on a per-port priority flow-control enable mode. Add the policy-map with the pfc-cos configuration to interface configurations to service at input to enable priority flow-control on that particular port, based on the port's priority flow-control enable mode. If you configure 40G to 10G mode on interfaces and pause (no drop) is enabled on system-qos, all queues may or may not drop traffic based on the availability of buffers. The no version of this command returns the value to the default.
OS10(conf-pmap-c-nqos)# pfc-cos 0-2
Example (global buffer/shared buffer)
OS10(config)# policy-map type network-qos nqGlobalpolicy1
                                       OS10(conf-cmap-nqos)# class CLASS-NAME
                                       OS10(conf-cmap-nqos-c)# pause buffer-size 45 pause-threshold 25 resume-threshold 10 
                                       OS10(conf-cmap-nqos-c)# pfc-cos 0-2
                                       OS10(conf-cmap-nqos-c)# queue-limit 140
Supported Releases
10.3.0E or later

Rate this content

Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\