OS10 Enterprise Edition User Guide Release 10.4.1.0

PDF

port-group

Configures a group of front-panel unified ports or a double-density QSFP28 (QSFP28-DD) port.

Syntax
port-group node/slot/port-group
Parameters
  • node/slot — Enter 1/1 for node/slot when you configure a port group.
  • port-group — Enter the port-group number (1–14). The available port-group range depends on the switch.
Default
Not configured
Command mode
CONFIGURATION
Usage information
Enter PORT-GROUP mode to:
  • Configure unified ports in Fibre Channel or Ethernet mode and break out interfaces with a specified speed.
  • Break out a QSFP28-DD port into multiple interfaces with a specified speed.
To view the ports that belong to a port group, enter the show port-group command.
Example
OS10(config)# port-group 1/1/8
                                       OS10(conf-pg-1/1/8)#
                                    
Supported releases
10.3.1E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\