OS10 Enterprise Edition User Guide Release 10.4.1.0

PDF

radius-server timeout

Configures the timeout used to resend RADIUS authentication requests.

Syntax
radius-server timeout seconds
Parameters
seconds — Enter the time in seconds for retransmission (0 to 1000).
Default
An OS10 switch stops sending RADIUS authentication requests after five seconds.
Command Mode
CONFIGURATION
Usage Information
Use this command to globally configure the timeout value used on RADIUS servers. The no version of this command resets the value to the default.
Example
OS10(config)# radius-server timeout 360
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\