OS10 Enterprise Edition User Guide Release 10.4.1.0

PDF

reachability-refresh

Configures a polling interval for reachability tracking.

Syntax
reachability-refresh interval
Parameters
interval — Enter the polling interval value (up to 3600 seconds).
Defaults
0 seconds
Command Mode
CONFIGURATION
Usage Information
Set the interval to 0 to disable the refresh.
Example
OS10(conf-track-100)# reachability-refresh 600
Supported Releases
10.3.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\