OS10 Enterprise Edition User Guide Release


Remote access

You can remotely access the OS10 command-line interface (CLI) and the Linux shell. When you install OS10 the first time, connect to the switch using the serial port.

Configure remote access

  • Configure the Management port IP address
  • Configure a default route to the Management port
  • Configure a user name and password

Remote access OS10 CLI

  1. Open an SSH session using the IP address of the device. You can also use PuTTY or a similar tool to access the device remotely.
    ssh admin@
                                        password: admin
  2. Enter admin for both the default user name and password to log into OS10. You are automatically placed in EXEC mode.

Remote access Linux shell

ssh linuxadmin@
                              password: linuxadmin

Rate this content

Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\