OS10 Enterprise Edition User Guide Release 10.4.1.0

PDF

router-id

Assigns a user-given ID to a BGP router.

Syntax
router-id ip-address
Parameters
ip-address — Enter an IP address in dotted decimal format.
Default
First configured IP address or random number
Command Mode
ROUTER-BGP
Usage Information
Change the router ID of a BGP router to reset peer-sessions. The no version of this command resets the value to the default.
  • NOTE: To configure these settings for a non default VRF instance, you must first enter the ROUTER-CONFIG-VRF sub mode using the following commands:
    1. Enter the ROUTER BGP mode using the router bgp as-number command.
    2. From the ROUTER BGP mode, enter the ROUTER BGP VRF mode using the vrf vrf-name command.
Example
OS10(conf-router-bgp-10)# router-id 10.10.10.40
Supported Releases
10.3.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\