OS10 Enterprise Edition User Guide Release 10.4.1.0

PDF

seq deny icmp

Assigns a filter to deny Internet Control Message Protocol (ICMP) messages while creating the filter.

Syntax
seq sequence-number deny icmp [A.B.C.D | A.B.C.D/x | any | host ip-address] [A.B.C.D | A.B.C.D/x | any | host ip-address] [capture | dscp value| fragment]
Parameters
  • sequence-number — Enter the sequence number to identify the route-map for editing and sequencing number, from 1 to 16777214.
  • A.B.C.D — Enter the IP address in dotted decimal format.
  • A.B.C.D/x — Enter the number of bits that must match the dotted decimal address.
  • any — (Optional) Set all routes which are subject to the filter:
    • capture — (Optional) Capture packets the filter processes.
    • dscp value — (Optional) Deny a packet based on the DSCP values, from 0 to 63.
    • fragment — (Optional) Use ACLs to control packet fragments.
  • host ip-address — (Optional) Enter the IP address to use a host IP address only.
Default
Not configured
Command Mode
IPV4-ACL
Usage Information
The no version of this command removes the filter, or use the no seq sequence-number command if you know the filter’s sequence number.
Example
OS10(config)# ip access-list egress
                                       OS10(conf-ipv4-acl)# seq 5 deny icmp any any capture session 1
                                    
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\