OS10 Enterprise Edition User Guide Release


seq permit (IPv6)

Assigns a sequence number to permit IPv6 packets, while creating a filter.

seq sequence-number permit protocol-number [A::B | A::B/x | any | host ipv6-address] [A::B | A:B/x | any | host ipv6-address] [capture | dscp value | fragment]
  • sequence-number — Enter the sequence number to identify the route-map for editing and sequencing number, from 1 to 16777214.
  • protocol-number — (Optional) Enter the protocol number, from 0 to 255.
  • A::B — Enter the IPv6 address in hexadecimal format separated by colons.
  • A::B/x — Enter the number of bits that must match the IPv6 address.
  • any — (Optional) Set all routes which are subject to the filter:
    • capture — (Optional) Enter to capture packets the filter processes.
    • dscp value — (Optional) Enter the DSCP value to permit a packet, from 0 to 63.
    • fragment — (Optional) Enter to use ACLs to control packet fragments.
  • host ipv6-address — (Optional) Enter the IPv6 address to be used as the host address.
Not configured
Command Mode
Usage Information
The no version of this command removes the filter, or use the no seq sequence-number command if you know the filter’s sequence number.
OS10(config)# ipv6 access-list ipv6test
                                       OS10(conf-ipv6-acl)# seq 10 permit ipv6 any any capture session 1
Supported Releases
10.2.0E or later

Rate this content

Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\