OS10 Enterprise Edition User Guide Release 10.4.1.0

PDF

seq permit ipv6

Assigns a sequence number to allow packets while creating the filter.

Syntax
seq sequence-number permit ipv6 [A::B | A::B/x | any | host ipv6-address] [A::B | A:B/x | any | host ipv6-address] [capture | dscp value | fragment]
Parameters
  • sequence-number — Enter the sequence number to identify the route-map for editing and sequencing number, from 1 to 16777214.
  • A::B — Enter the IPv6 address in hexadecimal format separated by colons.
  • A::B/x — Enter the number of bits that must match the IPv6 address.
  • any — (Optional) Set all routes which are subject to the filter:
    • capture — (Optional) Capture packets the filter processes.
    • dscp value — (Optional) Permit a packet based on the DSCP values, from 0 to 63.
    • fragment — (Optional) Use ACLs to control packet fragments.
  • host ipv6-address — (Optional) Enter the IPv6 address to use a host address only.
Default
Not configured
Command Mode
IPV6-ACL
Usage Information
The no version of this command removes the filter, or use the no seq sequence-number command if you know the filter’s sequence number.
Example
OS10(config)# ipv6 access-list egress
                                       OS10(conf-ipv6-acl)# seq 5 permit ipv6 any any capture session 1 
                                    
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\