OS10 Enterprise Edition User Guide Release 10.4.1.0

PDF

show ip ospf interface

Displays the configured OSPF interfaces. You must enable OSPF to display output.

Syntax
show ip ospf interface [ process-id] interface or show ip ospf [ process-id] interface [ interface]
Parameters
  • process-id — (Optional) Displays information for an OSPF Process ID. If you do not enter a Process ID, this command applies only to the first OSPF process.
  • interface — (Optional) Enter the interface information:
    • ethernet — Enter the Ethernet interface information (1 to 48)
    • port channel — Enter the port-channel interface number (1 to 128).
    • vlan — Enter the VLAN interface number (1 to ).
Default
Not configured
Command Mode
EXEC
Example
OS10# show ip ospf interface
                                       ethernet1/1/1 is up, line protocol is up
                                       Internet Address 10.0.0.2/24, Area 0.0.0.0
                                       Process ID 200, Router ID 10.0.0.2, Network Type broadcast, Cost: 1
                                       Transmit Delay is 1 sec, State DR, Priority 1
                                       Designated Router (ID) 10.0.0.2, Interface address 10.0.0.2 (local)
                                       Backup Designated router (ID) , Interface address 0.0.0.0
                                       Timer intervals configured, Hello 10, Dead 40, Wait 40, Retransmit 5
                                       Simple password authentication enabled
                                       Neighbor Count is 0, Adjacent neighbor count is 0
                                    
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\