OS10 Enterprise Edition User Guide Release 10.4.1.0

PDF

show ip ospf routes

Displays OSPF routes received from neighbors along with parameters like cost, next-hop, area, interface, and type of route.

Syntax
show ip ospf [ process-id] routes [prefix IP-prefix]
Parameters
  • process-id — (Optional) Enter OSPFv2 Process ID to view information specific to the ID.
  • IP-prefix — (Optional) Specify an IP address to view information specific to the IP address.
Default
None
Command Mode
EXEC
Usage Information
Displays the cost metric for each neighbor and interfaces.
Example
OS10# show ip ospf 10 routes
                                       Prefix           Cost        Nexthop         Interface     Area            Type
                                       110.1.1.0        1           0.0.0.0         vlan3050     0.0.0.0           intra-area
                                       111.1.1.0        1           0.0.0.0         vlan3051     0.0.0.0           intra-area
                                       111.2.1.0        1           0.0.0.0         vlan3053     0.0.0.0           intra-area
                                       
                                       
                                    
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\