OS10 Enterprise Edition User Guide Release 10.4.1.0

PDF

show ipv6 neighbors

Display IPv6 discovery information. Entering the command without options shows all IPv6 neighbor addresses stored on the control processor (CP).

Syntax
show ipv6 neighbors [vrf vrf-name] [ipv6-address| interface interface]
Parameters
  • vrf vrf-name — (Optional) Enter the keyword vrf and the name of the VRF to display the neighbors corresponding to that VRF. If you do not specify this option, neighbors corresponding to the default VRF are displayed.
  • ipv6-address — Enter the IPv6 address of the neighbor in the x:x:x:x::x format. The :: notation specifies successive hexadecimal fields of zero.
  • interface interface — Enter the keyword interface then the interface type and slot/port or number information:
    • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port/subport[/subport] information.
    • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information.
    • For a port channel interface, enter the keywords port-channel then a number.
    • For a VLAN interface, enter the keyword vlan then a number from 1 to 4093.
Defaults
None.
Command Mode
EXEC
Usage Information

The no version of this command resets the value to the default.

Example
OS10# show ipv6 neighbors
                                       IPv6 Address Expires(min) Hardware Address State Interface VLAN CPU
                                       --------------------------------------------------------------------
                                       100::1 0.03 00:00:00:00:00:22 DELAY Te 1/12 - CP
                                       fe80::200:ff:fe00:22 232 00:00:00:00:00:22 STALE Te 1/12 - CP
                                       500::1 0.60 00:01:e8:17:5c:af REACH Te 1/13 - CP
                                       fe80::200:ff:fe00:17 232 00:00:00:00:00:29 REACH Te 1/14 - CP
                                       900::1 0.60 00:01:e8:17:5c:b1 STALE Po 23 - CP
                                       400::1 0.60 00:01:e8:17:5c:ae REACH Te 1/2 Vl 100 CP
                                       OS10#
                                    
Supported Releases
10.4.1.0 or later or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\