OS10 Enterprise Edition User Guide Release 10.4.1.0

PDF

show vlan

Displays VLAN configurations.

Syntax
show vlan vlan-id
Parameters
vlan-id — (Optional) Enter a VLAN ID number (1 to 4093).
Default
Not configured
Command Mode
EXEC
Usage Information
Use this command to view VLAN configuration information for a specific VLAN ID.
Example
OS10(config)# do show vlan
                                       Codes: * - Default VLAN, M - Management VLAN, R - Remote Port Mirroring VLANs
                                       Q: A - Access (Untagged), T - Tagged
                                       NUM    Status    Description                     Q Ports
                                       *   1      Active                                    A Eth1/1/15
                                       A Po100
                                       2101   Active                                    T Eth1/1/1,1/1/3
                                       T Po100
                                       2102   Active                                    T Eth1/1/1,1/1/3
                                    
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\