OS10 Enterprise Edition User Guide Release 10.4.1.0

PDF

show vlt vlt-port-detail

Displays detailed status information about VLT ports.

Syntax
show vlt id vlt-port-detail
Parameters
id — Enter a VLT domain ID, from 1 to 255.
Default
Not configured
Command Mode
EXEC
Usage Information
The * in the mismatch output indicates a local node entry.
Example
OS10# show vlt 1 vlt-port-detail
                                       Vlt-port-channel ID : 1
                                       VLT Unit ID   Port-Channel    Status   Configured ports  Active ports
                                       ---------------------------------------------------------------------
                                       * 1           port-channel1   down     2                 0
                                       2           port-channel1   down     2                 0
                                       VLT ID : 2
                                       VLT Unit ID   Port-Channel    Status   Configured ports  Active ports
                                       ---------------------------------------------------------------------
                                       * 1           port-channel2   down     1                 0
                                       2           port-channel2   down     1                 0
                                       VLT ID : 3
                                       VLT Unit ID   Port-Channel    Status   Configured ports  Active ports
                                       ---------------------------------------------------------------------
                                       2           port-channel3   down     1                 0
                                    
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\