OS10 Enterprise Edition User Guide Release 10.4.1.0

PDF

shutdown

Disables an interface.

Syntax
shutdown
Parameters
None
Default
Disabled
Command Mode
INTERFACE
Usage Information

This command marks a physical interface as unavailable for traffic. Disabling a VLAN or a port-channel causes different behavior. When you disable a VLAN, the L3 functions within that VLAN are disabled, and L2 traffic continues to flow. Use the shutdown command on a port-channel to disable all traffic on the port-channel, and the individual interfaces. Use the no shutdown command to enable a port-channel on the interface. The shutdown and description commands are the only commands that you can configure on an interface that is a member of a port-channel.

Example
OS10(config)# interface ethernet 1/1/7
                                       OS10(conf-if-eth1/1/7)# no shutdown
                                    
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\