OS10 Enterprise Edition User Guide Release 10.4.1.0

PDF

soft-reconfiguration inbound

Enables soft-reconfiguration for a neighbor.

Syntax
soft-reconfiguration inbound
Parameters
None
Default
Not configured
Command Modes
ROUTER-BGP-NEIGHBOR-AF
Usage Information
This command is not supported on a peer-group level. To enable soft-reconfiguration for peers in a peer-group, this command must be enabled at a per-peer level. With soft-reconfiguration inbound, all updated received from this neighbor are stored unmodified, regardless of the inbound policy. When inbound soft-reconfiguration is performed later, the stored information is used to generate a new set of inbound updates. The no version of this command disables soft-reconfiguration inbound for a BGP neighbor.
Example (IPv4)
OS10(conf-router-neighbor)# address-family ipv4 unicast
                                       OS10(conf-router-bgp-neighbor-af)# soft-reconfiguration inbound
                                    
Example (IPv6)
OS10(conf-router-neighbor)# address-family ipv6 unicast
                                       OS10(conf-router-bgp-neighbor-af)# soft-reconfiguration inbound
                                    
Supported Releases
10.3.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\